Operating instructions

47
48
49
Answering Machine
48
Press and hold  Press and hold the button until the required setting
appears. Then release the button.
The setting is saved and is played back.
Listening−in to incoming messages
When the answering machine is switched on, you can listen to incoming calls without actually
taking the call.
If you do not want to listen to callers, simply set the answering machine volume to
zero.
If you want to take the call as the outgoing message is being played or a message is
being recorded, simply take the call in the normal way.
 Taking a call Page 48
Taking a call
When the answering machine is already answering a call, you can take it personally at any
time. Recording of the message is automatically stopped in this case.
 or  Take the call
Selecting answering mode
The answering machine is provided with two, pre−recorded outgoing messages. After outgoing
message 1 (OGM 1) has been played, the caller can leave a message. Outgoing message 2
(OGM 2) on the other hand is purely an announcement stating that no messages can be left. If
the answering machine memory is full, outgoing message 2 is automatically played to callers.
Both outgoing messages can be replaced by those of your own.
 First of all, switch the answering machine OFF.
2 sec  Activate Setup mode
 Activate outgoing message 1 (with recording)
 Activate outgoing message 2 (without recording)
Recording, controlling and deleting outgoing message
Your answering machine is provided with two pre−recorded outgoing messages  Select
answering mode. Both outgoing messages can be replaced by ones of your own or the pre−re-
corded, default messages restored.
Recording outgoing messages
An outgoing message must be at least 3 seconds long and a maximum of 3 minutes.
Please note: The longer the outgoing message, the less recording time is available
for incoming messages!
 Activate outgoing message mode.
Wait for the outgoing message.
Press and hold  or  Start OGM recording mode
To record outgoing message 1, press .
To record outgoing message 2, press .
  Speak your message after the acoustic signal.
Release  or  End recording mode.
The new outgoing message is played back.
Controlling the current outgoing message
 Play the outgoing message
 Stop playback