Operation Manual

GB-2
Power connection
Plug the AC POWER CORD (10) to the household outlet. Make sure the
voltage is correct for safety purposes and prevent plausible damages to the set.
Connect one 9V battery (not included) to the battery terminals in the BATTERY
COMPARTMENT (18). It maintains the clock continue function whenever the AC
power is interrupted.
Please note: the display will not exhibit time during power failure, but the clock
will keep correct time.
Radio operation
1. Slide the ON / OFF / AUTO switch (12) to the ON position
2. Slide the AM / FM BAND switch (13) to the desired waveband.
3. Tune to the desired station with the TUNING button (16).
4. Adjust the volume level with the VOLUME / BUZZ button (15).
5. To obtain a better FM reception, lay out the FM ANTENNA (11) wire to it’s full
extent.
6. The radio can be switched off by sliding the ON / OFF / AUTO button (12) to
the “OFF” position.
Setting the time
1. Press the TIME SET button (2) at the same time together with the HOUR
SET button (5) for hour setting or the MINUTE SET button (6) for minute
setting.
Setting the alarm
1. Press the ALARM SET button (3) at the same time together with the HOUR
SET button (5) for hour setting or the MINUTE SET button (6) for minute
setting.
2. Select the type of alarm (RADIO or BUZZER) and slide the ON / OFF / AUTO
switch (12) to the “AUTO” position.
RADIO: Wake to the radio, the radio must be tuned to a station which will be
broadcasting at the alarm time with the TUNING button (16) and the volume must
be adjusted to the desired level with the VOLUME / BUZZ button (15).
BUZZER: Wake to the buzzer, slide the VOLUME / BUZZ button (15) to it’s
minimum (in BUZZ position).
Interrupting the alarm (snooze function)
The alarm can be interrupted for 9 minutes by pressing the SNOOZE button (4)
after which time the radio or the alarm (RADIO or BUZZER) will come on again.