SATELLITE DIGITAL AUDIO CONTROL AND RECEIVER SYSTEM ® SATELLITE RECEIVER SYSTEM MODELS SRSIR-001, SRSIR-001FM and SRSIR-001FMR OWNER'S MANU AL MANUAL Released: 06-18-02. Revision A: Added Model Number: 08-20-02.
CONTENTS ABOUT SIRIUS® Trademarks ...................................................................................... 2 How to Subscribe to SIRIUS® Radio ................................................ 2 Introduction ........................................................................................ 2 How the System Operates ................................................................. 2 Satellite System Control Unit (SCU) ...................................................
2, 8 1 The FM Switching Box, in turn, is capable of transmitting on 7 FM frequencies; namely, 88.1MHz, 88.3MHz, 88.5MHz, 88.7MHz, 88.9MHz, 89.1MHz and 89.3MHz. The frequency is selected using the FM band of the existing vehicle radio. (The default FM frequency is 88.5MHz.) Select the FM frequency with the least noise or static, and then use the SCU to choose the SIRIUS® channel for your listening pleasure.
7. 8. 9. When pressed and held, this button allows you to switch between pre-set channel groups 1 and 2. This button is also used to invoke the Category Mode, which can also be achieved by Momentarily Pressing and Releasing the (SFT) button then Pressing and Holding the (SFT) button again for 2 seconds, “ENTER CATEGORY TUNE” or “ENTER CHANNEL TUNE” will be displayed . Power On/Off ( ) Button: Press this button to apply power to the Satellite Radio Receiver system.
. Functional Operation Functional operation of the system is controlled by the buttons on the SCU; i.e., the sequence in which they are pressed and the length of time button activation occurs. DISPLAYING THE IDENTIFICATION (ID) CODE POWERING UP THE SYSTEM Once the system is installed you must first subscribe to the SIRIUS® Radio service to activate the system. The SIRIUS® Radio service uses an ID code to identify your radio.
Confirmation Tone(s) Function A typical channel display will appear as shown below. CHANNEL NAME ARTIST NAME There are two basic functions of this feature; the Command Confirmation Tone, the Station Pre-Set Program Confirmation Tones. The following is a description of each of these functions: 1. Command Confirmation Tone - This function utilizes a single High Tone signal that is heard each time a button is pressed to confirm that the command was executed.
PRESS KEYPAD BUTTONS TO SELECT DESIRED CHANNEL CHANNEL NUMBER FLASHES The channel tuning will automatically wrap around from the last to the first channel in that category or vice-versa. When a new category is chosen, the radio will automatically select the first channel in that category. NOTE: If a directional button is Pressed and Held channels will begin to scroll in numerical sequence through all categories until the button is released.
Each category or group is assigned a sequential block of channels. To navigate within a category, enter Shift (SFT) 0981 Shift (SFT). This mode will allow the user to switch between channels within a chosen category.C 4. To program the second group of 10 preset channels (upper group) press and Hold the Shift (SFT) button for 2 seconds until a tone is heard. By doing this you have entered the second bank (upper group) and the SCU is ready to accept an additional group of 10 channels into memory. 5.
LCD BACKLIGHT DIMMING SHIFT CODE To enable the LCD backlight dimming feature: 1. Enter shift code 36, “DIMMING ADJUST” will be displayed. 2. Use the Up and Down directional buttons to increase or decrease display dimming, respectively. 3. Press the (SFT) button to exit LCD backlight dimming mode. BUTTON CONFIRMATION TONE SHIFT CODE . Normally, a beep confirmation tone is heard each time a button is pressed on the SCU. To silence this confirmation tone: 1. Enter code 40. 2.
DISPLAY MESSAGES When problems are encountered during SIRIUS® system operation, a message may appear on the display. The following table outlines the most common problems and provides a probable cause(s) for each and a suggested corrective action(s) to restore normal operation. Troubleshooting Considerations The following table presents a few possible causes of system operating faults, their probable causes and the remedial action suggested to restore the system to normal operating conditions.
Specifications GENERAL Power Source Max. Current Consumption Dimensions: Satellite System Control Unit (SCU) Satellite Radio Receiver Unit (RRU) Weight: Satellite System Control Unit (SCU) Satellite Radio Receiver Unit (RRU) 12 Vdc, Negative Ground 1.2 A 133mmL x 21.0mmW x 47.5mmH (5.24”) x (0.83”) x (1.87”) 170mmL x 114.9mmW x 30.5mmH (6.7”) x (4.5”) x (1.03”) 9.5 oz (0.269Kg) 23.0 oz (0.652Kg) FM Switching Box (For SRSIR-001FM) Usable Frequencies 88.1MHz, 88.3MHz, 88.5MHz, 88.7MHz, 88.9MHz, 89.1MHz, 89.
If you need help, just call Audiovox’s toll-free telephone assistance line at 1-800-645-4994 © 2002 AUDIOVOX ELECTRONICS CORP., HAUPPAUGE, N.Y.