User manual

Preparation
COMfortel 1200/1400 - Firmware Version 1.4 - COMfortel Set 3.6.0 - Setup V01 04/2014 45
ically changed in this way on the feet of the device may cause damage to
the surface of your furniture.
씮 Place the telephone on a non-slip pad.
Wall Mounting of the Telephone
Requirements
– Tools and material:
쐽
Drill and screw driver
쐽
Drilling template (see page page 65)
쐽
Two screws (as per DIN 96 or DIN 7996, head diameter 7 mm, not
included in the scope of delivery)
쐽
Two dowels (for a 5-mm hole, not included in the scope of delivery)
– Receiver connected
– ISDN cable connected (see Fig. 15 on page 46)
1. Hold the drilling template onto the area where the device is to be mounted
and place marks where the two mounting holes are to be drilled into the
wall.
Important: Make sure that there are no electrical leads, gas or water con-
ductions in the section where you want to drill the holes.
2. Drill the mounting holes (diameter 5 mm) and insert dowels into the holes.
3. Screw in the two screws far enough so that the screw head is about 5 mm
away from the wall.
4. Mount the telephone on the screws, then slide the telephone on the wall
downwards until the screws hit the stopper.