Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 101
Telephoning
Outgoing Calls
Initiating Callback on No Reply
1. Tap on .
If callback is configured, you will see the message Call completion activated.
2. Hang up the receiver.
As soon as the connection is no longer busy, the PBX will attempt to call you for 20
seconds.
3. Pick up the receiver to make the callback.
Notes:
If you do not pick up the receiver within the 20 seconds that the PBX calls
you, the callback instruction will be deleted.
If you would like to cancel the callback, tap on .
If you pick up the receiver, the subscriber will be called.
Note: A callback will be stored in the PBX for up to 45 minutes. If the called
subscriber has not yet finished their call, the callback will be deleted automat-
ically.
Initiating Callback on No Reply
Requirements:
– Both telephones must be connected to the same Auerswald PBX.
If no one answers on the connection you are calling, proceed as described below.
1. Tap on .
If callback is configured, you will see the message Call completion activated.
2. Hang up the receiver.
As soon as the connection has been occupied, the PBX will call you back for 30
seconds.
3. Pick up the receiver to make the callback.