Operation Manual

154 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Do-Not-Disturb
Switching the Do-Not-Disturb Function On/Off
Do-Not-Disturb
The do-not-disturb function allows you to block calls to your own telephone. The caller then
hears the busy tone. An internal subscriber can reach a telephone with call protection in an
emergency using a priority call.
The do-not-disturb function has no effect on outgoing calls, callbacks, alarm calls, wake-up
calls or InterCom calls.
Switching the Do-Not-Disturb Function On/Off
If the do-not-disturb function is switched on, the specified call types will are not signalled on the
telephone.
The do-not-disturb type indicates which call types it affects when it is switched on.
Notes:
Rejected calls are not added to the caller list on the telephone.
The function is switched on in the telephone and can be used as an alter-
native, or in addition, to the do-not-disturb function in the Auerswald PBX. A
call deblocker that is configured and enabled in the Auerswald PBX will only
apply when the telephone is used as a system telephone in the PBX.
Likewise, a priority call made from an internal telephone on the PBX will only
apply when the telephone is used as a system telephone in the PBX.
You can switch the do-not-disturb function on or off as follows:
• Using the telephone
To activate or deactivate the do-not-disturb function, press the function key that has been
configured for do-not-disturb.
Alternatively, proceed as described below.
1. Tap:
• Functions listed alphabetically: Apps > Functions > Do-not-disturb
• Functions sorted by group: Apps > Functions > Availability > Do-
not-disturb
2. In the Operation list field, select one of the following options: