Operation Manual

176 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Targeted Exchange Line Access (System Telephone)
Configuring and Operating a Function Key for Targeted Exchange Line Access
Configuring and Operating a Function Key for Targeted Exchange Line Access
Press the key to initiate targeted exchange line access. You can then immediately dial the
external telephone number (without exchange line access number).
In addition, when functions are defined on the first key level, the status of the account is
indicated by the corresponding LED.
You can configure a function key for targeted exchange line access as follows:
• Using the configuration manager
• Using the telephone
Note: The function can only be set up on a programmable function key that
has an LED (not on a touch function key).
Using the Configuration Manager to Configure a Function Key for Targeted Exchange
Line Access
1. Open the Apps > Function keys screen.
2. Only COMfortel 2600/3600 IP: In the Key selection list field, select the key group
whose keys you would like to define.
Note: Keys 16 to 105 are not available until you connect COMfortel
Xtension300 key extension modules (not included in the scope of delivery) to
the telephone.
3. Click one of the following tabs:
LED signalling on the key:
red All the account's call channels are occupied (call not possible).
yellow At least one of the account's call channels is available. Press the key to use
the call channel that is still available.
off All the account's call channels are available. Press the key to occupy one of
the available call channels.
Level 1: Keys are assigned on the first key level.
Level 2: Keys are assigned on the second key level.