Operation Manual

182 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Groups (System Telephone)
Configuring and Operating a Function Key for the Group Function
In addition, when functions are assigned on the first key level, the status of the function is
indicated by the corresponding LED.
You can configure the function key for the group function as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Configure a Function Key for the Group Function
Requirements:
– The telephone is a member of at least one group configured in the PBX
1. Open the Apps > Function keys screen.
2. Only COMfortel 2600/3600 IP: In the Key selection list field, select the key group
whose keys you would like to define.
Note: Keys 16 to 105 are not available until you connect COMfortel
Xtension300 key extension modules (not included in the scope of delivery) to
the telephone.
3. Click one of the following tabs:
4. In the list field next to the function key that you would like to define, select the function
Group.
Note: To change the settings for a function key that already has a function
assigned to it, click on that key.
LED signalling on the key:
green The telephone is logged in to the group for incoming and outgoing calls.
yellow The phone is logged in to the group as incoming or outgoing according to the
Call direction key assignment.
off The telephone is logged out of the group according to the Call direction key
assignment.
Level 1: Keys are assigned on the first key level.
Level 2: Keys are assigned on the second key level.