Operation Manual

188 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015

Functions

Groups (System Telephone)

Configuring and Operating a Function Key for Displaying the Group State

Press the key while the telephone is in the idle state to display the current group state of the

subscribers (logged out, logged in as incoming and/or outgoing) on the LEDs of configured

speed dialling keys for approx. 10 seconds. For this purpose the speed dialling keys must be

assigned to the corresponding subscriber telephone numbers. Press the key again within 10

seconds to cancel the display.

You can configure a function key to display the group state as follows:

• Using the configuration manager

• Using the telephone

Using the Configuration Manager to Configure a Function Key for Displaying the Group

State

Requirements:

– The telephone is a member of at least one group configured in the PBX

1. Open the Apps > Function keys screen.

2. Only COMfortel 2600/3600 IP: In the Key selection list field, select the key group

whose keys you would like to define.

LED signalling on the key:

green

(blinking)

The group state is being queried.

off The group state is not being queried.

LED signalling on the speed dialling keys assigned to subscriber telephone numbers:

red The telephone is logged out of the group.

green The telephone is logged in to the group for incoming and outgoing calls.

yellow The telephone is logged in to the group for incoming calls.

yellow

(blinking)

The telephone is logged into the group for outgoing calls.