Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 197
Functions
InterCom OneWay/Speakerphone
Configuring and Operating a Function Key for InterCom OneWay
– A function key configured for InterCom OneWay
– Telephone is a system telephone on an Auerswald PBX or InterCom OneWay is performed
on an Auerswald PBX for which the sequence ##011 has been entered under Settings >
Providers & PBXs > Name of Provider/PBX > Numbers > Special numbers > Keypad
sequence for InterCom speakerphone.
Note: The InterCom OneWay announcement can also be made from any
internal telephone (see the PBX manual).
Depending on the kind of action configured on the key, proceed as described.
1. Press the function key for InterCom OneWay or press and hold the function key.
The LED next to the function key lights up green to show a call connection is present.
2. To end the announcement, press the function key again or release the function key.
Configuring and Operating a Function Key for InterCom OneWay
Press the key when the telephone is in its idle state to select the subscriber telephone number
or group telephone number stored on the key and initiate the InterCom OneWay
announcement. Depending on the kind of action configured, you need to hold the key during
the announcement (as soon as you release the key again, the connection is terminated) or
switch the key over by briefly pressing the key (the key is pressed once at the start and once
at the end).
In addition, when InterCom destination is defined on the first key level, the status of the
InterCom destination connection is indicated by the corresponding LED.
LED signalling on the key (when assigned to an internal subscriber telephone
number):
green There is currently an active connection to the InterCom destination.
off There is currently no active connection to the InterCom destination.