Operation Manual

200 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
InterCom OneWay/Speakerphone
Configuring and Operating a Function Key for InterCom OneWay
Note: The LEDs of the function keys that are already filled on one level light
up yellow. If a function key is assigned on both levels, the LED is red.
3. Select one of the following options:
The list of available functions is displayed.
4. Tap on InterCom OneWay.
The current settings for assigning the key are shown on the display.
5. In the Description entry field, enter a description for the key. Possible entries:
Note: The key description is used for printing the label and in the display.
6. In the Operation list field, select one of the following options:
7. In the Account list field, select the account for the required PBX.
8. Enter the required in-house telephone number in the InterCom destination entry
field.
9. Tap on Assign.
10. Tap on Exit.
Requirements for using the function:
– Telephone is a system telephone on an Auerswald PBX or InterCom OneWay is performed
on an Auerswald PBX for which the sequence ##011 has been entered under Settings >
Providers & PBXs > Name of Provider/PBX > Special numbers > Keypad sequence for
InterCom speakerphone
– InterCom permission is present at the InterCom destination
Level 1: Keys are assigned on the first key level.
Level 2: Keys are assigned on the second key level.
Up to 64 digits
Numbers and characters
Hold: The key must be held down during the announcement.
toggle: A short press of the key starts the announcement. Another short press
of the key ends the announcement.