Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 201

Functions

InterCom OneWay/Speakerphone

How InterCom Hands-Free Works

The InterCom speaker phone function works like this:

• A system telephone is called using the InterCom speaker phone function.

• After a few rings, the system telephone automatically picks up the call.

• The hands-free call is carried out.

Note: For security reasons, hands-free calling (speakerphone) is limited to

120 seconds to prevent possible misuse of this function (for example, eaves-

dropping from distant rooms).

• After 120 seconds has elapsed, the connection is automatically interrupted unless the

system telephone receiver is picked up during this time.

Using InterCom Speaker Phone

Requirements:

– InterCom permission is present at the InterCom destination

– A function key configured for InterCom speaker phone

– Telephone is a system telephone on an Auerswald PBX or InterCom OneWay is performed

on an Auerswald PBX for which the sequence ##012 has been entered under Settings >

Providers & PBXs > Name of Provider/PBX > Numbers > Special numbers > Keypad

sequence for InterCom speakerphone.

Note: InterCom speaker phone calls can also be performed by any internal

telephone (see the PBX manual).

Depending on the kind of action configured on the key, proceed as described.

1. Press the function key for InterCom speaker phone or press and hold the function

key.

The LED next to the function key lights up in green to show that a call connection is

present.

2. To end the announcement or hands-free calling function, press the function key

again or release the function key.