Operation Manual

202 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015

Functions

InterCom OneWay/Speakerphone

Configuring and Operating a Function Key for InterCom Speaker Phone

Press the key when the telephone is in its idle state to select the telephone number stored on

the key and initiate the InterCom speaker phone announcement. Depending on the kind of

action configured, you need to hold the key during hands-free operation (as soon as you

release the key again, the connection is terminated) or switch the key over by briefly pressing

the key (the key is pressed once at the start and once at the end).

In addition, when InterCom destination is defined on the first key level, the status of the

InterCom destination connection is indicated by the corresponding LED.

You can configure a function key for the InterCom speaker phone function as follows:

• Using the configuration manager

• Using the telephone

Note: The function can only be set up on a programmable function key that

has an LED (not on a touch function key).

Using the Configuration Manager to Configure a Function Key for InterCom Speaker

Phone

1. Open the Apps > Function keys screen.

2. Only COMfortel 2600/3600 IP: In the Key selection list field, select the key group

whose keys you would like to define.

Note: Keys 16 to 105 are not available until you connect COMfortel

Xtension300 key extension modules (not included in the scope of delivery) to

the telephone.

3. Click one of the following tabs:

LED signalling on the key:

green There is currently an active connection to the InterCom destination.

green

(blinking)

The InterCom call is sent to the PBX.

red InterCom destination not accessible.

off There is currently no active connection to the InterCom destination.