Operation Manual

214 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015

Functions

Macro Function

Configuring and Operating a Function Key for the Macro Function

Press the key while the telephone in the idle state (sleep) to execute a macro. If the H command

(hang-up/pick-up with the hook key) is located at the beginning of a macro, the macro saved in

the system is run immediately. If this is not the case, you need to first confirm you want the

macro function to start.

In addition, you can read the status of the relevant macro on the LED.

Note: The commands for controlling LEDs are used on both levels of the

keys. This makes it possible, for instance, to use the macro to switch the LED

on, on the one key level, and to use the macro to switch LED off on the other

key level. In this way the switching status of a different function that is

enabled at the same time can be seen on the LED.

You can configure a function key for the macro function as follows:

• Using the configuration manager

• Using the telephone

Note: The function can only be set up on a programmable function key that

has an LED (not on a touch function key).

Using the Configuration Manager to Configure a Function Key for the Macro Function

1. Open the Apps > Function keys screen.

2. Only COMfortel 2600/3600 IP: In the Key selection list field, select the key group

whose keys you would like to define.

Note: Keys 16 to 105 are not available until you connect COMfortel

Xtension300 key extension modules (not included in the scope of delivery) to

the telephone.

3. Click one of the following tabs:

LED signalling on the key:

Depending on the purpose of the commands Lo, Lg, Lr and Ly.