Operation Manual

216 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Macro Function
Configuring and Operating a Function Key for the Macro Function
Notes:
If you want to configure a programming function on the PBX as a macro,
enter a pause between the password and the programming code sequence.
Pauses cannot be entered at the beginning of a macro.
The maximum pause time is 5 seconds. This restriction does not apply for
the C command (waiting for a connection).
The commands for controlling LEDs are used on both levels of the keys.
This makes it possible, for instance, to use the macro to switch the LED on,
on the one key level, and to use the macro to switch LED off on the other
key level. In this way the switching status of a different function that is
enabled at the same time can be seen on the LED.
8. In the Permission level list field, select one of the following options:
Further steps:
– Save your settings before you leave the screen.
Using the Telephone to Configure a Function Key for the Macro Function
1. Tap on Apps > Function keys.
2. Press the function key you want to define.
Note: The LEDs of the function keys that are already filled on one level light
up yellow. If a function key is assigned on both levels, the LED is red.
3. Select one of the following options:
Ly The LED next to the function key switches on (yellow)
Lg The LED next to the function key switches on (green)
User: The function key can be changed by users, sub-administrators and
administrators.
Sub-administrator: The function key can only be changed by sub-adminis-
trators and administrators.
Administrator: The function key can only be changed by administrators.
Level 1: Keys are assigned on the first key level.
Level 2: Keys are assigned on the second key level.