Operation Manual

220 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Pick-Up
Configuring and Operating a Function Key for Pick-Up
– Telephone is a system telephone on an Auerswald PBX or pick-up is performed on an
Auerswald PBX for which the sequence ##06 has been entered under Settings > Providers
& PBXs > Name of Provider/PBX > Special numbers > Keypad sequence for pickup.
If you are already taking a call, and an internal telephone rings somewhere near you, proceed
as described below.
1. Press the function key configured for pick-up.
2. In the selection window, select the required VoIP account and a telephone number.
Note: If you would like to take a call that is directed to a group, select the pick-
up for the group telephone number.
3. Tap on the caller's business card or tap on .
You are now connected with the caller. Your previous call partner hears the on-hold
music.
Configuring and Operating a Function Key for Pick-Up
Open the selection window by pressing the key that is not assigned to a specific pick-up
number. You can then enter the internal telephone number of the telephone that is ringing.
Open the caller's business card by pressing the key assigned to a specific pick-up number.
In addition, if you press the key, this initiates a call pick-up on telephones or answering
machines for which permission has been given (refer to the instructions for the PBX).
Note: If you frequently take pick-ups for specific telephones, you can
configure a speed dialling key for the associated internal subscriber/group
telephone number as an alternative to this key. You then see a red blinking
LED indicating that the telephone number is being called. You can press the
speed dialling key and, following confirmation, take the call on your
telephone.
You can configure a function key for pick-up as follows:
LED signalling on the key:
None