Operation Manual

226 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Relays (System Telephone)
Switching Relays On/Off
Relays (System Telephone)
If the PBX is equipped with one or more relays, they can be switched on and off, depending on
the relay function configured for each telephone.
Switching Relays On/Off
You can switch relays on or off as follows:
• Using the telephone
Requirements:
– The telephone is a system telephone in an Auerswald PBX
– Switching of relay permission granted in the PBX
– The relay in the PBX has been set up with the Configuration-dependent, PC relayor
manual relay operating modes (refer to the PBX manual for different options here)
To switch a relay on or off, press the function key that has been configured for switching
relays.
Alternatively, proceed as described below.
1. Tap:
• Functions listed alphabetically: Apps > Functions > Relay
• Functions sorted by group: Apps > Functions > Door functions/
Relays > Relay
2. In the Operation list field, select one of the following options:
3. Select the relay:
• Manual entry: Enter a relay ID in the Relay ID entry field.
• Selection: Tap on and select a relay ID.
4. Tap on Execute.
switch on: Switches the relay on.
switch off: Switches the relay off.