Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 227

Functions

Relays (System Telephone)

Configuring and Operating a Function Key for Switching Relays

Press the key to switch the configured relay on or off or to switch it over.

In addition, when functions are defined on the first key level, the status of the relay is indicated

by the corresponding LED.

You can configure a function key for switching relays as follows:

• Using the configuration manager

• Using the telephone

Using the Configuration Manager to Configure a Function Key for Switching Relays

Requirements:

– The relay in the PBX has been set up with the Configuration-dependent, PC relayor

manual relay operating modes (refer to the PBX manual for different options here)

1. Open the Apps > Function keys screen.

2. Only COMfortel 2600/3600 IP: In the Key selection list field, select the key group

whose keys you would like to define.

Note: Keys 16 to 105 are not available until you connect COMfortel

Xtension300 key extension modules (not included in the scope of delivery) to

the telephone.

3. Click one of the following tabs:

4. In the list field next to the function key that you would like to define, select the Relay

function.

Note: To change the settings for a function key that already has a function

assigned to it, click on that key.

LED signalling on the key:

green The relay configured on the key is enabled.

off The relay configured on the key is disabled.

Level 1: Keys are assigned on the first key level.

Level 2: Keys are assigned on the second key level.