Operation Manual

238 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Call Forwarding
Configuring and Operating a Function Key for Call Forwarding for Subscribers
6. Tap on Execute.
Configuring and Operating a Function Key for Call Forwarding for Subscribers
Press the key assigned to Call fwd. (scr.) to switch call forwarding for subscribers for the
configured destination on or off, or to switch it over, in the telephone.
Press a single key assigned to Call fwd. (scr.), deactivate all to switches off all currently
enabled call forwardings for the subscriber.
In addition, when functions are assigned on the first key level, the status of the function is
indicated by the corresponding LED.
You can configure the function key for call forwarding for subscribers as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Configure a Function Key for Call Forwarding for
Subscribers
1. Open the Apps > Function keys screen.
2. Only COMfortel 2600/3600 IP: In the Key selection list field, select the key group
whose keys you would like to define.
Note: Keys 16 to 105 are not available until you connect COMfortel
Xtension300 key extension modules (not included in the scope of delivery) to
the telephone.
3. Click one of the following tabs:
LED signalling on the key (not applicable if assigned with "Call fwd. (scr.), deactivate
all":
red Subscriber call forwarding is enabled for the configured destination.
yellow Subscriber call forwarding is enabled for a different destination.
off Subscriber call forwarding is disabled.