Operation Manual

244 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015

Functions

Call Forwarding

Switching Call Forwarding for Subscribers in the PBX On/Off

Note: The function is switched on in the PBX. The telephone does not have

any messages about forwarded calls. The calls are not saved in the call log.

You can switch call forwarding for subscribers on or off as follows:

• Using the telephone

Requirements:

– The telephone is a system telephone in an Auerswald PBX

To enable or disable call forwarding for subscribers, press a function key configured for Call

fwd (scr. in PBX).

Alternatively:

1. Tap:

• Functions listed alphabetically: Apps > Functions > Call fwd. (scr. in

PBX)

• Functions sorted by group: Apps > Functions > Accessibility >

Call fwd. (scr. in PBX)

2. In the Operation list field, select one of the following options:

3. In the Forwarding type list field, select one of the following options:

4. Select the call forwarding destination:

• Manual entry: Enter the destination number in the Forwarding destination entry

field. Possible entries:

switch on: Switches on call forwarding for subscribers.

switch off: Switches off call forwarding for subscribers. (No further action is

required.)

unconditional: Switches "Call fwd. unconditional" (unconditional call

forwarding) on or off for subscribers.

on busy: Switches "Call fwd. on busy" (call forwarding on busy) on or off for

subscribers.

not responding: Switches call forwarding "on no reply" on or off for

subscribers.