Operation Manual

44 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Introduction to the Telephone
Device Overview
Display
Display-LED (only COMfortel 1400 IP and COMfortel 3600 IP)
The display LED signals the operational state of the telephone, missed calls and new
messages. You can select differenet settings (see chapter Settings > Display > Configuring the
Display LED (only COMfortel 1400 IP and COMfortel 3600 IP).
Sensors (only COMfortel 3600 IP)
Brightness sensor
If the automatic brightness adjustment function is switched on, the brightness sensor is used
to adjust the display lighting to the brightness of the telephone's surroundings. The user can
choose to either set te required brightness manually or switch to automatic adjustment (see
chapter Settings > Display > Setting the Brightness of the Display).
Proximity sensor
The proximity sensors detect for example user proximity or a motion in front of the telephone.
The sensitivity of the proximity sensors can be set (see chapter Settings > Display > Setting
the Sensitivity of the Proximity Sensor (only COMfortel 3600 IP). This can be used to exit the
power save mode or the ring signal during a call via waving (see chapter Settings > Sound >
Switching Silence on User Proximity On/Off (only COMfortel 2600 IP).
Display
The following image shows the telephone display with an open Home screen.
A Status bar