Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 461
Settings
Providers and PBXs
Configuring the Outbound Proxy
1. Tap on Apps > Settings > Providers & PBXs.
2. Tap on the name of the provider/PBX.
3. Under SIP settings, tap on Registrar.
4. Select or clear the Registrar check box.
5. Tap on Registrar address and then enter the registrar. Possible entries:
6. Tap on OK.
7. Tap on Registrar port and then enter the port number (port). Possible entries:
8. Tap on OK.
9. Tap on Registration interval (min) and enter a value. Possible entries:
Note: In the test phase, after you have set up the provider/PBX, we
recommend you enter a low value (e.g. three minutes). After completing the
test phase, you can enter a much higher value.
10. Tap on OK.
Configuring the Outbound Proxy
The outbound proxy is an intermediate server that processes all VoIP requests and connec-
tions going to the provider (except for registration).
You can configure the outbound proxy as follows:
• Separately for the provider or PBX
• Using the configuration manager
• Using the telephone
Switches the registrar On.
Switches the registrar Off. (No further action is required.)
IP address with a range of 0 to 255 (example: 103.103.103.103)
URL (example: registrar.uk)
1 to 65535
1 to 60: The PBX then registers itself again with the provider/on the PBX after
this specified interval (1 to 60 minutes).