Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 485
Settings
Providers and PBXs
Entering Keypad Sequences
2. Tap on the name of the provider/PBX.
3. Under Number settings, tap on Special numbers.
4. Tap on Exchange line access number and then enter the exchange line access
number in the entry field. Possible entries:
Note: In the factory settings, the PBX's exchange line access number is "0",
but it can be changed in some PBXs (refer to the instructions for the PBX).
5. Tap on OK.
Entering Keypad Sequences
Keypad sequences enable you to control performance features by entering characters and
number sequences via the phone keys, e.g. to make pick-ups or InterCom OneWay announce-
ments.
Important: If operated as a system telephone on an Auerswald PBX, the
keypad sequences are predefined by the PBX. The PBX overwrites any
keypad sequences you have entered manually.
The following keypad sequences are available when the telephone is running on a PBX:
• Pick-up
The keypad sequence is required to carry out pick-ups on PBXs where a pick-up
sequence is mandatory for this function. Information from SIP notify messages are
not taken into consideration.
• InterCom OneWay
The keypad sequence is required to make an InterCom OneWay announcement.
InterCom OneWay announcements can also be made on accounts where the
telephone is not used as system telephone.
• InterCom speaker phone
The keypad sequence is required to enable Intercom hands-free calling at a desti-
nation which does not support automatic call acceptance.
• Alarm confirmation
The keypad sequence is required to acknowledge an alarm call with the keypad.
You can enter keypad sequences as follows:
Numbers