Operation Manual

506 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Settings
Accounts
Enabling/Disabling Use as a System Telephone
If the telephone is not a system telephone on any account, only the additional PBX
accounts, which allow direct exchange line access, are available. It is no longer
possible to access a specific exchange line.
Note: The changed account status is displayed after you have saved the
changes and left the screen.
Further steps:
– Make further settings on the configuration screen.
– Save your settings before you leave the screen.
Using the Telephone to Enable/Disable Use as a System Telephone
Requirements:
– Connection to one of the following Auerswald PBXs: COMpact 4000, COMpact 5010 VoIP,
COMpact 5020 VoIP with firmware version 4.2E or higher, COMpact 5000/R with firmware
version 6.2A or higher, COMmander 6000/R/RX with firmware version 6.0C or higher
1. Tap on Apps > Settings > Accounts.
2. In the Account overview, tap on the required account.
3. Select or clear the Auerswald system telephone check box.
The current account status is displayed in the Account overview and appears in the
Account settings dialogue like this:
If the telephone is not a system telephone on any account, only the additional PBX
accounts, which allow direct exchange line access, are available. It is no longer
possible to access a specific exchange line.
Further steps:
– Make further settings.
Enables use as a system telephone.
Disables use as a system telephone.
Auerswald system telephony enabled.
Auerswald system telephony disabled.