Operation Manual

514 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Settings
Accounts
Configuring the Connection Type
Note: You can also enter the country code directly in the Country code field
(with 00, and a maximum of six digits). However, this entry is overwritten as
soon as you select a different country.
Further steps:
– Make further settings.
Configuring the Connection Type
An account can be operated with the following connection types:
• Standard connection: corresponds to a Point-to-Multipoint Connection with several
internal telephone numbers (MSNs).
• SIP trunking: is the same as a Point-to-Point Connection with a direct dial-in option. The
VoIP provider assigns a DDI main number with a direct dial-in (DDI), e. g. 92 00 - 0.
You can configure the connection type as follows:
• Separately for each account
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Set the Type of Connection
1. Open the Settings > Accounts screen.
2. In the line that contains the required account, click Configure.
3. Under Type of connection, select one of the following options:
Note: If you have selected the SIP trunking connection type, you must then
enter a DDI main number. The DDI main number setting is now shown as
enabled (no longer greyed out).
Further steps:
– For SIP trunking, enter the DDI main number.
– Make further settings on the configuration screen.