Operation Manual

536 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Settings
Network
Configuring the RTP Port
Using the Configuration Manager to Switch the DiffServ Function On/Off
Requirements:
– Available and enabled support for DiffServ in all active network components
1. Open the Settings > Network > Network screen.
2. Under Settings for VoIP,select or deselect the Quality of Service check box.
DiffServ (Differentiated Services).
3. Only if DiffServ is enabled: Restart the telephone.
Further steps:
– Save your settings before you leave the screen.
Using the Telephone to Switch the DiffServ Function On/Off
Requirements:
– Available and enabled support for DiffServ in all active network components
1. Tap on Apps > Settings > Network > Network.
2. Tap on VoIP.
3. Select or clear the Quality of Service check box. DiffServ (Differentiated
Services).
4. Only if DiffServ is enabled: Restart the telephone.
Configuring the RTP Port
The RTP port is a port on the local system that is used as the outgoing port for RTP transfers.
You can configure the RTP port as follows:
Switches DiffServ on. The following DSCP values are set for VoIP calls (as
proposed in RFC 4594): Signalling (SIP): CS5, Voice (RTP): EF
Switches DiffServ off.
Switches DiffServ on. The following DSCP values are set for VoIP calls (as
proposed in RFC 4594): Signalling (SIP): CS5, Voice (RTP): EF.
Switches DiffServ off.