Operation Manual

566 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015

Settings

Display and LEDs

Idle State (Sleep) and Power Save Mode

In its idle state (sleep), the display no longer reacts to touch and the selected screen candy is

displayed ( Apps > Settings > Device > Sound > Screen candy).

In power save mode, the display's backlight is dimmed or switched off and the LEDs are not

active (with the exception of the message LED which blinks for missed calls). The power save

mode is switched on and of depending on the idle state (sleep).

The idle state (sleep) can be switched on automatically after a specified waiting time or

manually if the user presses a function key.

If operated on an Auerswald PBX, the configuration set up in the PBX can be used to switch

the idle state (sleep) on and off (time control).

The idle state (sleep) is switched off automatically if, for example, an incoming call is signalled,

or if the alarm rings.

Notes:

If the screen lock has been set, it is enabled automatically when the idle

state (sleep) is enabled ( Apps > Settings > Personal >

Security > Screen lock).

Configuring the Idle State (Sleep)

The waiting time specifies how much time must elapse after the last action (e. g. pressing a

key, tapping the display, making a telephone call) before the screen lock is enabled.

You can configure automatic screen lock in power save mode as follows:

• Using the configuration manager

• Using the telephone

Using the Configuration Manager to Set the Idle State (Sleep)

1. Open the Settings > Device > Display screen.

2. Under Sleep select one of the following options: