Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 567
Settings
Display and LEDs
Configuring the Power Save Mode
Further steps:
– Save your settings before you leave the screen.
Using the Telephone to Set the Idle State (Sleep)
1. Tap on Apps > Settings > Device > Display.
2. Tap on Sleep and select one of the following options from the list field:
Configuring the Power Save Mode
The waiting time specifies after which interval the power save mode is switched on in the idle
state (sleep).
You can configure the power save mode as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Configure the Power Save Mode
1. Open the Settings > Device > Display screen.
2. Under Power save mode behaviour select one of the following options:
Not automatically: No idle state (sleep).
15 seconds to 30 minutes: Switches on the idle state (sleep) after the
selected time.
Not automatically: No idle state (sleep).
15 seconds to 30 minutes: Switches on the idle state (sleep) after the
selected time.
never: No power save mode.
without timeout: Switches on the power save mode together with the idle
state (sleep), without delay.
after 5 minutes to after two hours: Switches on the power save mode after
the set time.