Operation Manual

570 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Settings
Display and LEDs
Configuring and Operating a Function Key for the Idle State (Sleep)
Using the Configuration to Switch On/Off Automated Switching Off of the Display in
Power Save Mode
Requirements:
– Idle state (sleep) and power save mode must be set
1. Open the Settings > Device > Display screen.
2. Under Brightness select or clear the Display off check box.
Further steps:
– Save your settings before you leave the screen.
Using the Telephone to Switch On/Off Automated Switching Off of the Display in Power
Save Mode
Requirements:
– Idle state (sleep) and power save mode must be set
1. Tap on Apps > Settings > Device > Display > More.
2. Select or clear the Display off check box.
Configuring and Operating a Function Key for the Idle State (Sleep)
If you press the key you switch the idle state (sleep) on immediately.
Notes:
If the power save mode is enabled, it will be switched on together with the
idle state (sleep) ( Apps > Settings > Device > Display > More
> Power save mode behaviour).
As the function key LEDs are switched off in power save mode, you cannot
use them to tell you which status the functions currently have.
Switches the display off completely in power save mode.
Dims the display in power save mode.
Switches the display off completely in power save mode.
Dims the display in the power save mode.