Operation Manual

576 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015

Settings

Display and LEDs

Configuring the Display LED (only COMfortel 1400 IP and COMfortel 3600 IP)

The display LED signal is used to shows the telephone's operational state, missed calls and

new messages.

If you find the LED signals disruptive or annoying, they can be switched off. A number of

different settings are available here:

You can configure the display LED as follows:

• Using the configuration manager

• Using the telephone

Using the Configuration Manager to Configure the Display LED

1. Open the Settings > Device > Display screen.

2. Under Display LED, select one of the following options:

LED signalling for the following setting: Display calls, conversations and new

messages

red The telephone is engaged.

red (blinking) You have new messages.

red (flashing +

alternating pauses)

The telephone is being called.

off The telephone is neither engaged nor being called, and no new

messages are present.

LED signalling for the following setting: Display calls and conversations

red The telephone is engaged.

red (flashing +

alternating pauses)

The telephone is being called.

off The telephone is neither engaged nor being called.

LED signalling for the following setting: LED always off

off LED is switched off.