Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 599

Settings

IP Camera

Configuring Motion Detection and Switching It On/Off

If you have an IP camera which supports motion detection, it can be used to switch on the IP

camera app automatically.

Note: You must make camera-specific settings to enable motion detection on

the camera (see instructions for the IP camera).

You can configure motion detection as follows:

• Using the configuration manager

• Using the telephone

Using the Configuration Manager to Configure Motion Detection and Switch IT On/Off

1. Open the Settings > Auerswald > IP camera screen.

2. In the line containing the required IP camera, click Configure.

3. Select or clear the Motion Detection check box under IP camera Motion Detection.

4. In the TCP port (for all IP cameras) entry field, enter the associated port number.

Possible entries:

5. In the TCP message entry field, enter the TCP message set for the IP camera (TCP

trigger). Possible entries:

6. In the Attention tone list field, select the required attention tone.

Further steps:

– Save your settings before you leave the screen.

Using the Telephone to Configure Motion Detection and Switch IT On/Off

1. Tap on Apps > Settings > Auerswald > More > IP camera.

Switches motion detection on.

Switches motion detection off. (No further action is required.)

1 to 65535

Up to 64 digits

Numbers and characters