Operation Manual

600 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Settings
IP Camera
Configuring a Link Between an IP Camera and a Contact
2. Tap on the name of the IP camera.
3. Tap on Motion Detection.
4. Select or clear the Motion Detection check box.
5. Tap on TCP port (for all IP cameras and enter the associated port number in the
entry field. Possible entries:
6. Tap on TCP message and enter the TCP message (TCP trigger) specified for the IP
camera in the entry field. Possible entries:
7. Tap on Attention tone and the attention tone you want to use from the list field.
8. Tap on OK.
Configuring a Link Between an IP Camera and a Contact
If the link from the IP camera to a contact is active, the IP camera is automatically displayed in
the telephony app as soon as you receive a call from the contact or call the contact yourself.
By sending DTMF signals you can open a door and switch on the accompanying stairwell light
(connection between the IP camera and a door station in the telephone book).
You can configure a link between an IP camera and a contact as follows:
• Using the telephone
1. Press the Contact/Telephone book key.
2. Scroll to the required contact or enter the first letter of their name using the keypad.
3. Tap on the name of the contact.
4. Press the Menu key.
5. Tap on Options.
Switches motion detection on.
Switches motion detection off. (No further action is required.)
1 to 65535
Up to 64 digits
Numbers and characters