Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 637
Service and Maintenance
Update and Provisioning
Configuring the Schedule for Updates and Provisioning
2. Tap on the firmware file displayed under Update SD card.
3. Tap on Update.
As soon as the firmware is installed in the telephone, a dialogue opens.
4. To activate the new firmware, tap on Reboot.
Note: To restart the telephone at a later point in time, tap on Cancel and then,
under Apps > Settings > System > Shutdown/Reboot, tap on
Reboot when you want to restart the telephone.
The telephone is restarted.
Further steps:
– After a firmware update you usually require a new version of the instructions. You will find up-
to-date instructions on the Internet (see www.auerswald.de/service).
– In order to use the new features after the telephone's firmware has been updated, you often
may need to update the PBX firmware (see PBX operation instructions).
Configuring the Schedule for Updates and Provisioning
The schedule specifies the weekday and time at which the update and provisioning are to be
performed.
Note: To avoid overloading of the provisioning server, the automatic update
and provisioning starts within a time slot of 60 minutes after the set time.
You can configure the schedule for updates and provisioning as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Configure the Schedule for Updates and Provi-
sioning
1. Open the Settings > System > Update & provisioning > Update screen.
2. In the Time entry field, under Schedule, enter the required time. Possible entries: