Operation Manual

644 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Service and Maintenance
Update and Provisioning
Entering the Address of the Update Server
– In order to use the new features after the telephone's firmware has been updated, you often
may need to update the PBX firmware (see PBX operation instructions).
Entering the Address of the Update Server
To automatically update the firmware you must enter the address of the update server. The
address of the update server is already entered in the factory settings. However, if it is not
present, or if you would like to change the address, follow the instructions below.
You can enter the address of the update server as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Enter the Address of the Update Server
1. Open the Settings > System > Update & provisioning > Update screen.
2. In the Update server URL entry field, under Automatic Update, enter the address of
the update server. Possible entries:
Further steps:
– Save your settings before you leave the screen.
Using the Telephone to Enter the Address of the Update Server
1. Tap on Apps > Settings > System > Update & provisioning.
2. Under Automatic update, tap on Update server.
3. In the Update server entry field, enter the update server's address. Possible entries:
4. Tap on OK.
IP address with a range of 0 to 255 (example: 103.103.103.103)
URL (example: www.auerswald-update.uk)
IP address with a range of 0 to 255 (example: 103.103.103.103)
URL (example: www.auerswald-update.uk)