Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 645

Service and Maintenance

Update and Provisioning

Configuring Automatic Update via the Update Server

When performing an automatic update the system checks whether a new firmware update is

available on the update server, at the set point in time. If an update is available, the new

firmware is loaded into the telephone if the automatic installation of updates is selected.

You can configure an automatic update via the update server as follows:

• Using the configuration manager

• Using the telephone

Using the Configuration Manager to Automatically Perform an Update via the Update

Server

Requirements:

– The PBX or telephone must be connected to a broadband Internet connection

– Address of the DNS server entered on the Settings > Network > Network screen

– The set schedule must be entered on the Settings > System > Update & provisioning >

Update screen

– The address of the update server must be entered on the Settings > System > Update &

provisioning > Update screen

– When the automatic update is performed: SD card inserted into slot (min 128 MB of free

memory )

1. Open the Settings > System > Update & provisioning > Update screen.

2. Select or clear the Check for updates check box.

Note: If only the Check for updates check box is selected, the system only

checks for the availability of a new firmware version and, if there is one, it

displays it. The firmware is not updated until the Automatically install

update check box is selected.

3. Select or clear the Automatically install update check box.

The availability of a new firmware version is checked. If a new firmware version is

available, it is uploaded to the telephone and the telephone is restarted.

Switches on the check for availability of a new firmware version.

Switches off the check for availability of a new firmware version.

Switches on automatic update.

Switches off automatic update.