Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 647
Service and Maintenance
Update and Provisioning
Triggering an Update Test
– In order to use the new features after the telephone's firmware has been updated, you often
may need to update the PBX firmware (see PBX operation instructions).
Triggering an Update Test
If you have entered the address of an update server, you can check the update settings and
the functioning of the server by performing an update.
You can trigger an update test as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Initiate an Update Test
Requirements:
– The PBX or telephone must be connected to a broadband Internet connection
– The address of the DNS server must be entered in Settings > Network > Network
– The address of the update server must be entered in Settings > System > Update & provi-
sioning > Update
– SD card inserted into slot (min 128 MB of free memory )
1. Open the Settings > System > Update & provisioning > Update screen.
2. Click on Firmware Update.
3. Click Update.
The check for new firmware is carried out.
If no firmware file is available on the update server, a warning message is displayed
to tell you that no new firmware is available.
If the telephone's update settings are incorrect, a warning message is displayed to tell
you that the check for new firmware was unsuccessful.
If the update settings of the telephone are correct and a firmware file is available on
the update server, the new firmware is installed. The telephone is restarted, and the
login window opens.
Note: To restart the telephone at a later point in time, tap on Cancel and then,
under Settings > System > Update & provisioning > Reboot, tap on
Reboot when you want to restart the telephone.