Operation Manual

648 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Service and Maintenance
Update and Provisioning
Triggering an Update Test
4. Log in with you username and password and tap on OK.
Further steps:
– After a firmware update you usually require a new version of the instructions. You will find up-
to-date instructions on the Internet (see www.auerswald.de/service.
– In order to use the new features after the telephone's firmware has been updated, you often
may need to update the PBX firmware (see PBX operation instructions).
Using the Telephone to Trigger an Update Test
Requirements:
– The PBX or telephone must be connected to a broadband Internet connection
– The address of the DNS server must be entered in Apps > Settings > Network >
Network
– The update server's address must be entered under Apps > Settings > System >
Update & provisioning > Automatic update
– SD card inserted into slot (min 128 MB of free memory )
1. Tap on Apps > Settings > System > Update & provisioning.
2. Under Automatic update, tap on Firmware update.
If the update settings of the telephone are correct and a firmware file is available on
the update server, a dialogue opens.
If no firmware file is present on the update server, a warning message is displayed to
tell you that no new firmware is available.
If the telephone's update settings are incorrect, a note appears in the telephone's
status line to tell you that the check for new firmware was unsuccessful.
3. Tap on Download.
As soon as the firmware is saved in the telephone, a dialogue opens.
4. Tap on Install.
As soon as the firmware is installed in the telephone, a dialogue opens.
5. To activate the new firmware, tap on Reboot.
Note: To restart the telephone at a later point in time, tap on Cancel and then,
under Apps > Settings > System > Shutdown/Reboot, tap on
Reboot when you want to restart the telephone.