Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 73
Introduction to the Configuration Manager
Configuration Manager
Opening the Configuration Manager
Configuration Manager
The configuration manager provides an easy way for you to set up the telephone on your
computer. The configuration manager can be accessed via the integrated web server in the
telephone. The PC you need for doing this must either be connected directly to an Ethernet port
on the telephone or be in the same network.
Opening the Configuration Manager
You can open the configuration manager using one of the recommended browsers and the
telephone's IP address.
To open the configuration manager during operation as a system telephone, you must first log
in to the telephone. You can log in at the following authority levels:
• Administrator
• Sub-Administrator
• User
Note: Because sun-ranges of the system telephone can be closed by the
administrator, it may happen that you will be unable to make all the settings
in the telephone if you register as a user or sub-administrator (see Settings>
Permissions).
Opening the Configuration Manager when Operating the System Telephone as an
Administrator
Requirements:
– A PC meeting the minimum requirements (see chapter Important Information > Minimum
Requirements PC)
– The telephone is a system telephone in an Auerswald PBX
– You need to know the admin password for the PBX
– You need to know the telephone's IP address (you can check it on the telephone by selecting
Apps > Settings > Network > Network > IP address)
– Existing network connection between the PC and the system telephone
1. Start a browser (e.g. Mozilla Firefox).