Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 149
Functions
Call Waiting
Switching Call Waiting On/Off
Call Waiting
If you are already in a call, the call waiting function plays the call waiting tone to notify you that
another call partner is calling.
Switching Call Waiting On/Off
If call waiting is switched on, you will be notified of any incoming calls if you are already on
another call.
If the audible signal and call waiting are switched on, a tone in the receiver will notify the user
(when already on a call) that another call is incoming. If the audible signal is switched off,
incoming calls will be signalled only in the display.
Note: This function is switched on in the telephone. The call waiting function
that is accessible in the telephone should be switched on at all times to
ensure that the PBX will pass all calls to the telephone (this is unnecessary if
the telephone is being used as a system telephone on an Auerswald PBX).
You can switch call waiting on or off as follows:
• Using the telephone
To enable or disable call waiting, press the function key that has been configured for call
waiting.
Alternatively, proceed as described below.
1. Tap:
• Functions listed alphabetically: Apps > Functions > Call waiting
• Functions sorted by group: Apps > Functions > Availability >
Call waiting
2. In the Operation list field, select one of the following options:
3. In the Audible indication list field, select one of the following options:
switch on: Enables call waiting.
switch off: Disables call waiting. (No further selection is required.)