Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 155
Functions
Do-Not-Disturb
Configuring and Operating a Function Key for Do-Not-Disturb
3. In the Reject callers list field, select one of the following options:
4. Tap on Execute.
Configuring and Operating a Function Key for Do-Not-Disturb
Press the key to switch do-not-disturb on or off or to switch it over.
In addition, when functions are assigned on the first key level, the status of the function is
indicated by the corresponding LED.
You can configure a function key for do-not-disturb as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Configure a Function Key for Do-not-disturb
1. Open the Apps > Function keys screen.
switch on: Enables the do-not-disturb function.
switch off: Disables the do-not-disturb function. (No further selection is
required.)
reject all callers: When do-not-disturb is switched on, all incoming calls will be
rejected.
reject anonymous: When do-not-disturb is switched on, all anonymous calls
will be rejected.
reject if not in contacts: When do-not-disturb is switched on all calls are
rejected except for calls from contacts listed in the telephone book.
LED signalling on the key:
green Do-not-disturb is switched on and all of the settings assigned to the key are in
agreement.
yellow Do-not-disturb is switched on but at least one of the settings assigned to the
key is not in agreement.
off The do-not-disturb function is disabled.