Operation Manual

192 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Headset Operation
Configuring and Operating a Function Key for Headset Operation
Notes:
Switching on automatic call acceptance automatically switches off any
answering machine in a telephone. Conversely, switching on an answering
machine will switch off automatic call acceptance ("Auto-accept").
The COMfortel DECT headset's automatic call acceptance function
applies solely to call acceptance between the COMfortel DECT headset and
the associated base station. Its settings do not affect automatic call
acceptance between the headset and the telephone.
4. Enter a value in the Auto-accept timeout entry field. Possible entries:
5. Tap on Execute.
Configuring and Operating a Function Key for Headset Operation
Press the key to switch headset operation on or off or to switch it over.
In addition, when functions are assigned on the first key level, the status of the function is
indicated by the corresponding LED.
You can configure a function key for headset operation as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Configure a Function Key for Headset Operation
1. Open the Apps > Function keys screen.
0 to 99: After 0 to 99 seconds, an incoming call is automatically accepted,
depending on the entry.
LED signalling on the key:
green Headset operation is enabled.
yellow Headset operation is switched on but at least one of the settings assigned to
the function key is not in agreement.
off Headset operation is disabled.