Operation Manual

210 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Configuration Switchover (System Telephone)
Configuring and Operating a Function Key for Configuration Switchover
In addition, when functions are assigned on the first key level, the status of the function is
indicated by the corresponding LED.
You can configure the function key for configuration switchover as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Configure a Function Key for Configuration
Switchover
Requirements:
– At least two configurations have been set up in the PBX
1. Open the Apps > Function keys screen.
2. Only COMfortel 2600/3600 IP: In the Key selection list field, select the key group
whose keys you would like to define.
Note: Keys 16 to 105 are not available until you connect COMfortel
Xtension300 key extension modules (not included in the scope of delivery) to
the telephone.
3. Click one of the following tabs:
4. In the list field next to the function key you would like to define, select the Configu-
ration function.
Note: To change the settings for a function key that already has a function
assigned to it, click on that key.
The current settings for the key assignment are shown in the display.
5. In the Description entry field, enter a description for the key. Possible entries:
LED signalling on the key:
green The configuration saved in the key is enabled.
off The configuration saved in the key is disabled.
Level 1: Keys are assigned on the first key level.
Level 2: Keys are assigned on the second key level.