Operation Manual

260 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Telephone Line
Configuring and Operating a Function Key for the Telephone Line
Note: You cannot run this function if the account stored for a function key has
been deleted. When you press the key, a dialogue opens, in which you can
assign a new account to the key. Tap on New accountnext to the Account ID,
select a new account from the list field and then tap on Assign.
You can configure a function key for the telephone line as follows:
• Using the configuration manager
• Using the telephone
Note: The function can only be set up on a programmable function key that
has an LED (not on a touch function key).
LED signalling on the key (when assigned to an internal subscriber telephone
number):
red A call is currently being held on the telephone or the user is attempting to
establish a connection.
red (blinking) The telephone is now being called, and the caller's business card is not linked
with the toolbar (in the background).
If you pick up the receiver and press the key, this puts the call on hold.
red (blinks
twice)
The telephone is now being called, and the caller's business card is linked
with the toolbar.
If you pick up the receiver and press the key, this puts the call on hold.
yellow The call is held locally in the telephone and the caller's business card is not
connected to the toolbar.
Press the key twice to pick up the call.
yellow (blinks
twice)
The call is held locally in the telephone and the caller's business card is
connected to the toolbar.
Press the key once to pick up the call.
yellow (blinks
quickly)
The telephone dials the telephone number after you press the function key.
off No call is pending. Press the key to initiate a call through the assigned
account.
Timeout: The function key is blocked for approximately 2 to 3 seconds after a
call over a Telephone line has been completed.