Operation Manual
270 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Functions
Door Function (System Telephone)
Using the Door Function
Door Function (System Telephone)
If a door terminal system is connected to the PBX's interface you can run the following
functions. A call with the door (intercom) can be held from any telephone. During a call to the
door, the door can be opened (open door) and a stairwell light controlled by switching a relay
(switch on light).
These functions can be performed on the system telephone even without a pending door call.
Using the Door Function
You can operate the door function as follows:
• Using the telephone
Requirements:
– The telephone is a system telephone in an Auerswald PBX
– Telephone number configured in the PBX for the door station
– Relays configured in the PBX for opening the door and the stairwell light.
– Open door permission granted in the PBX
To operate the door function, press the function key configured for the door function.
Alternatively, proceed as described below.
1. Tap:
• Functions listed alphabetically: Apps > Functions > Door functions
• Functions sorted by group: Apps > Functions > Door functions/
relays > Door functions
2. In the Operation list field, select one of the following options:
3. Select a door:
• Manual entry: Enter a telephone number in the Door number entry field.
• Selection: Tap on and select a door.
open: Opens the door.
switch on light: Switches the stairwell light on.
open door - switch on light: Opens the door and switches the stairwell light
on.