Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 273
Functions
Door Function (System Telephone)
Configuring and Operating a Function Key for the Door Function
You can configure a function key for the door function as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Configure a Function Key for the Door Function
Requirements:
– Telephone number configured in the PBX for the door station
– Relays configured in the PBX for opening the door and the stairwell light.
1. Open the Apps > Function keys screen.
2. Only COMfortel 2600/3600 IP: In the Key selection list field, select the key group
whose keys you would like to define.
Note: Keys 16 to 105 are not available until you connect COMfortel
Xtension300 key extension modules (not included in the scope of delivery) to
the telephone.
3. Click one of the following tabs:
4. In the list field next to the function key you would like to define, select the Door
function function.
Note: To change the settings for a function key that already has a function
assigned to it, click on that key.
The current settings for the key assignment are shown in the display.
5. In the Description entry field, enter a description for the key. Possible entries:
LED signalling on the key:
green The door opening function and/or the light are switched on.
yellow The light is switched on.
off None of the functions configured on the key are enabled.
Level 1: Keys are assigned on the first key level.
Level 2: Keys are assigned on the second key level.