Operation Manual

460 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Settings
Providers and PBXs
Configuring the Registrar
Using the Configuration Manager to Configure the Registrar
Requirements:
– Set DNS server
1. Open the Settings > Providers & PBXs screen.
2. In the line that contains the provider/PBX, click Configure.
The provider/PBX configuration screen opens.
3. Under Registrar settings, select or clear the Registrar check box.
4. Under Registrar settings, enter the SIP port in the Registrar address entry field.
Possible entries:
5. Under Registrar settings, enter the port number in the Registrar port entry field.
Possible entries:
6. Under Registrar settings, enter a value in the Registration interval (min.) entry
field. Possible entries:
Note: In the test phase, after you have set up the provider/PBX, we
recommend you enter a low value (e.g. three minutes). After completing the
test phase, you can enter a much higher value.
Further steps:
– Save your settings before you leave the screen.
Using the Telephone to Configure the Registrar
Requirements:
– Set DNS server
Switches the registrar On.
Switches the registrar Off. (No further action is required.)
IP address with a range of 0 to 255 (example: 103.103.103.103)
URL (example: registrar.uk)
1 to 65535
1 to 60: The telephone then registers itself again with the provider/to the PBX
after this specified interval (1 to 60 minutes).