Operation Manual

568 COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015
Settings
Display and LEDs
Switching Configuration-Dependent Idle State (Sleep) On/Off
Further steps:
– Save your settings before you leave the screen.
Using the Telephone to Configure the Power Save Mode
1. Tap on Apps > Settings > Device > Display > More.
2. Tap on Power save mode behaviour and select one of the following options from the
list field:
Switching Configuration-Dependent Idle State (Sleep) On/Off
If the configuration-dependent idle state (sleep) is enabled, the telephone goes into its idle state
when you switch to a specific PBX configuration (for example, night configuration).
Note: If the power save mode is enabled, it will be activated together with the
idle state (sleep) ( Apps > Settings > Device > Display > More
> Power save mode behaviour).
You can switch the configuration-dependent idle state (sleep) on and off as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Configure the Configuration-Dependent Idle State
(Sleep)
Requirements:
– Operation on Auerswald PBX
– At least two configurations have been set up in the PBX
1. Open the Settings > Device > Display screen.
never: No power save mode.
without timeout: Switches on the power save mode together with the idle
state (sleep), without delay.
after 5 minutes to after two hours: Switches on the power save mode after
the set time.