Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 569
Settings
Display and LEDs
Enabling/Disabling Automated Switching Off of the Display in Power Save Mode
2. Under Configuration-dependent power save, enter the identification number of the
required configuration in the Configuration ID entry field.
Note: To switch off the configuration-dependent idle state (sleep), delete the
configuration ID in the Configuration-ID entry field.
Further steps:
– Save your settings before you leave the screen.
Using the Telephone to Configure the Configuration-Dependent Idle State (Sleep)
Requirements:
– Operation on Auerswald PBX
– At least two configurations have been set up in the PBX
1. Tap on Apps > Settings > Device > Display > More.
2. Under Configuration-dependent power save, tap on Configuration ID and then
input the ID number of the required configuration in the entry field.
3. Tap on OK.
Note: To switch off the configuration-dependent idle state (sleep), delete the
configuration ID in the Configuration ID entry field and then tap on OK.
Enabling/Disabling Automated Switching Off of the Display in Power Save Mode
If the power save mode of the telephone is switched on, the display automatically switches
completely off after a certain time.
You can configure the display in power save mode as follows:
• Using the telephone
• Using the configuration manager