Operation Manual

COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 575
Settings
Display and LEDs
Setting the Message Key LED
You can configure the LED for the message key as follows:
• Using the configuration manager
• Using the telephone
Using the Configuration Manager to Configure the LED for the Message Key
1. Open the Settings > Device > Display screen.
2. Under Message LED, select one of the following options:
Further steps:
– Save your settings before you leave the screen.
Using the Telephone to Configure the LED for the Message Key
1. Tap on Apps > Settings > Device > Display > More.
2. Under LED settings, tap on Message LED and select one of the following options
from the list field:
LED signalling on the key:
red No new entries are present. All the entries in the list have been viewed, but
have not yet been deleted.
red (blinking) The list contains new entries that have not yet been viewed.
off LED is switched off.
Flashing and always on: Indicates new (red (blinking) entries, or entries that
have already been viewed (lit in red).
Flashing only: Indicates new entries (red (blinking).
Off: LED is always switched off.
Flashing and always on: Indicates new (red (blinking) entries, or entries that
have already been viewed (lit in red).
Flashing only: Indicates new entries (red (blinking).
Off: LED is always switched off.