Operation Manual
COMfortel 1400IP/2600IP/3600IP - Firmware V2.2G - Operation and Configuration V03 07/2015 577
Settings
Display and LEDs
Setting the Sensitivity of the Proximity Sensors (only COMfortel 3600 IP)
Further steps:
– Save your settings before you leave the screen.
Using the Telephone to Configure the Display LED
1. Tap on Apps > Settings > Device > Display > More.
2. Under LED settings, tap on Display LED and select one of the following options from
the list field:
Setting the Sensitivity of the Proximity Sensors (only COMfortel 3600 IP)
The proximity sensors detect for example user proximity or a motion in front of the telephone.
You can configure the sensitivity of the proximity sensors as follows:
• Using the telephone
1. Tap on Apps > Settings > Device > Display > More > Proximity sensor.
2. Tap on the slider and set the required sensitivity.
You can tell which proximity range you are currently located in by the colour of the two
stars.
• Both stars grey: You are currently outside the proximity range.
Show alerting and calls: Indicates the status of the call.
Show alerting, calls and headset activation: Indicates the status of the call
and the headset activation (only COMfortel 3600 IP).
Show alerting, calls and new messages: Indicates the status of the call and
also new messages.
Off: LED is always switched off.
Show alerting and calls: Indicates the status of the call.
Show alerting, calls and headset activation: Indicates the status of the call
and the headset activation (only COMfortel 3600 IP).
Show alerting, calls and new messages: Indicates the status of the call and
also new messages.
Off: LED is always switched off.